Power Connection Diagram (Frame C); Power Connection Diagram (Frame D) - Parker 650G Product Manual

Power Connection Diagram (Frame C)

Brake resistor and cable must be screened
if not fitted inside a control cubicle
All screens terminated using a gland at the gland plate
1. Remove the terminal cover retaining screws and lift off the terminal cover.
2. Lift the internal power terminal shield.
3. Feed the power supply and motor cables into the drive through the metal gland plate using

Power Connection Diagram (Frame D)

Brake resistor and cable must be screened
if not fitted inside a control cubicle
All screens terminated using a gland at the gland plate
1. Remove the terminal cover retaining screws and lift off the terminal cover.
2. Lift the internal power terminal shield.
3.
4. Lower the internal power terminal shield.
650G AC Drive
L1
L2 L3
PE1
3PH PE L1 L2 L3
the correct cable entries, and connect to the power terminals. Tighten all terminals to the
correct tightening torque, refer to the Terminal Tightening Torques table. Lower the
internal power terminal shield.
Power Board
L1 L2 L3
PE1
PE L1
3PH L2 L3
Feed the power supply and motor cables into the drive through the metal gland plate using
the correct cable entries, and connect to the power terminals. Tighten all terminals to the
correct tightening torque, refer to the Terminal Tightening Torques table.
www.comoso.com
Installing the Drive
DC+ DC- M1/U M2/V M3/W
PE2
M
DC+ DC- M1/U M2/V M3/W
PE2
M
3-16
MOT/TEMP
DBR+ DBR-
brake
resistor
motor thermistor
MOT/TEMP
DBR+ DBR-
motor thermistor
brake
resistor