Control Features - Parker 650G Product Manual

2-6
An Overview of the Drive

Control Features

The drive is fully-featured when controlled using the optional Keypad (or a suitable PC
programming tool).
DEFAULT
Table Chapter 2-1 Control Features
The `General' control features below are not user-selectable when the unit is controlled using
the analog and digital inputs and outputs.
General Output
Frequency
Switching
Frequency
Voltage Boost
Flux Control
Skip
Frequencies
Preset Speeds
Stopping
Modes
S Ramp and
Linear Ramp
Raise/Lower
Jog
Logic Functions
Value Functions
Diagnostics
Protection Trip Conditions
Current Limit
Voltage/
Frequency
Profile
Inputs/ Analog Inputs
Outputs
Analog
Outputs
Digital Inputs
Digital I/O
Relay Outputs
www.comoso.com
Selectable 0-240Hz
Frames 1, 2 & 3: 4kHz nominal
Frames C, D, E & F 3kHz nominal
0-25%
1. V/F control with linear or fan law profile
2. Sensorless vector with automatic flux control and slip
compensation
2 skip frequencies with adjustable skip band width
8 presets
Ramp, coast, dc injection, fast stop
Symmetric or asymmetric ramp up and down rates
Programmable MOP function
Programmable jog speed
10 programmable 3-input logic function blocks
performing NOT, AND, NAND, OR, NOR and XOR
functions, for example
10 programmable 3-input value function blocks
performing IF, ABS, SWITCH, RATIO, ADD, SUB,
TRACK/HOLD, and BINARY DECODE functions, for
example
Full diagnostic and monitoring facilities
Output short line to line, and line to earth
Overcurrent > 200%
Stall
Heatsink overtemperature
Motor Thermistor overtemperature
Overvoltage and undervoltage
Adjustable 110% or150%
180% shock load limit
Inverse Time
Constant torque
Fan Law
2 inputs – one is configurable; voltage or current
1 configurable voltage output
6 configurable 24V dc inputs (2 suitable for encoder
inputs)
1 configurable 24V dc open collector outputs/digital
inputs
1 configurable relay output
650G AC Drive