Installing The Drive; Mechanical Installation; Mounting The Drive; Ventilation - Parker 650G Product Manual

3-1

Installing the Drive

I
NSTALLING THE
Chapter 3
IMPORTANT: Read Chapter 10: "Certification for the Drive" before installing this unit.

MECHANICAL INSTALLATION

650G Frames 1, 2 & 3
D
SIDE VIEW - Frame 1 illustrated
Fixing Torque
Frame 1 M4 1.5Nm
Frame 2 M5 3.0Nm
Frame 3 M5 3.0Nm

Mounting the Drive

To DIN mount the unit, hang the unit on the top DIN rail and push the unit onto the bottom DIN
rail until it snaps in to position. Secure with a lower screw fixing. To release the unit, use a flat
bladed screwdriver as shown.

Ventilation

Maintain a minimum air clearance for ventilation of 100mm (4
inches) above and below the unit. When mounting two or more
650G units together, these clearances are additive. Ensure that the
mounting surface is normally cool. Be aware that adjacent
equipment may generate heat and also have clearance requirements.
Provided the minimum clearance for ventilation is maintained, 650G
drives may be mounted side-by-side.
The DIN clip is repositioned on Frames 1 and 2
to provide the upper fixing hole when wall-mounting
W
DIN
centreline
H2
W
2
REAR VIEW - Frame 1 illustrated
(Frame 2 similar)
Weight H1 Fixing Centres
0.85kg 132
(2 lbs) (5.2")
1.4kg 188
(3 lbs) (7.4")
2.7kg 242
(6 lbs) (9.5")
www.comoso.com
D
RIVE
H3
C
H4
H3
H2
H1
H4
H2 H3 H4
143 35 139
(5.6") (1.4") (5.5")
201 35 194
(7.9") (1.4") (7.7")
260 38 112
(10.2") (1.5") (4.4")
Dimensions are in millimetres ( inches )
W
C
DIN
centreline
H1
DIN centreline
W
2
REAR VIEW - Frame 3
C W D
6 73 142
(0.2") (2.9") (5.6")
6.5 73 173
(0.24") (2.9") (6.8")
5 96 200
(0.2") (3.8") (7.9")
lower
fixing
hole
650G AC Drive