Parker 650G Product Manual page 73

MMI Parameters Table
Display Parameter
SKIP FREQUENCY
2
SKIP FREQUENCY
BAND 2
AUTO RESTART
ATTEMPTS
AUTO RESTART
DELAY
AUTO RESTART
TRIGGERS
AUTO RESTART
TRIGGERS+
DB ENABLE
DB RESISTANCE
DB POWER
DB OVER-RATING Multiplier that may be applied to DB POWER for
TORQUE
FEEDBACK
TORQUE LEVEL
USE ABS
TORQUE
F
LOCAL MIN
SPEED F
650G AC Drive
Programming Your Application
Description
This parameter contains the centre frequency of
skip band 2 in Hz
The width of skip band 2 in Hz
Determines the number of restarts that will be
permitted before requiring an external fault reset
Determines the delay between restart attempts for
a trip included in AUTO RESTART TRIGGERS and
AUTO RESTART TRIGGERS+. The delay is
measured from all error conditions clearing
Allows Auto Restart to be enabled for a selection of
trip conditions.
Refer to Chapter 7: "Trips and Fault Finding" -
Hexadecimal Representation of Trips
Allows Auto Restart to be enabled for a selection of
trip conditions.
Refer to Chapter 7: "Trips and Fault Finding" -
Hexadecimal Representation of Trips
Enables operation of the dynamic braking.
The value of the load resistance.
The power that the load resistance may continually
dissipate.
power overloads lasting no more than 1 second.
Shows the estimated motor torque, as a
percentage of rated motor torque.
This parameter sets the value of load at which AT
LOAD becomes TRUE. AT LOAD may be
connected to a digital output. Refer to
s DOP3. 100% = rated torque for the motor.
When TRUE, the direction of rotation is ignored. In
this case, the comparison level should always be
positive.
When FALSE, the direction of rotation is not
ignored. Driving a load in the reverse direction
gives a negative value for torque. In this case, the
comparison level may be positive or negative.
The magnitude of the minimum setpoint that will
be used when running in Local Mode.
www.comoso.com
Range
0.0 to 240.0 Hz
0.0 to 60.0 Hz
0 to 10
0.0 to 600.0 s
0x0000 to 0xFFFF
0x0000 to 0xFFFF
0=FALSE
1=TRUE
1 to 1000
0.1 to 510.0 kW
1 to 40
—
.xx %
-300.0 to 300.0 %
s DOP1 to
0=FALSE
1=TRUE
0.0 to 100.0 %
6-10
Default
0.0
0.0
0
10.0
0x0000
0x0000
1
product
code
dependent
product
code
dependent
25
—
.xx %
100.0 %
0
0.0 %