How To Change A Parameter Value; Special Menu Features; Resetting To Factory Defaults (2-Button Reset); Changing The Drive Operating Frequency - Parker 650G Product Manual

5-4
The Keypad

How To Change a Parameter Value

You can change the values of parameters stored in the
6: "Programming Your Application" – Configurable Parameters for further information.
 View the parameter to be edited and press
 Select the digit to be changed (pressing the
 Use the
 Press

Special Menu Features

Resetting to Factory Defaults (2-button reset)

Power-up the drive whilst holding the keys as
shown to return to factory default settings.
This loads Application 1. Then press the
key.

Changing the Drive Operating Frequency

Power-up the drive whilst holding the keys as
shown to display the Engineers Menu.
IMPORTANT: This menu contains sensitive parameters that
can dramatically alter the running of the drive.
This displays parameter
edit the parameter: 0 = 50Hz (default), 1 = 60Hz. Select the required frequency then press the
Power-down the drive. No permanent change has been made to the drive at this point. To save
the change to parameter
that this will return the drive to its factory default settings for the selected default frequency.

Selecting Local or Remote Control

The drive can operate in one of two ways:
Remote Control:
Local Control:
Local control keys are inactive when Remote Control is selected.
In Remote Control, the drive uses a remote setpoint. In Local Control, it uses the Local Setpoint
parameter whose value is adjusted on the MMI.
You can only change between Local and Remote Control when the drive is "stopped",
Note:
and either
Remote to Local Control:
650G AC Drive
keys to adjust the value. Hold the key momentarily to adjust the value
marginally, or hold the key to make rapid changes; the rate of change varies with the time
held.
to return to the parameter display. The new value is stored.
E
0.01. Press the
key.
E
0.02, you must now perform a 2-button reset (as above). Please note
or the Local Setpoint is displayed.
Hold this key down until
the display shows
Hold this key down until
the display spells
Release the key to display
the Local Setpoint
www.comoso.com
to display the parameter's value.
key moves the cursor from right to left).
Hold down the keys opposite:
Power-up the drive, continue
to hold for at least 1 second
Hold down the keys opposite:
Power-up the drive, continue
to hold for at least 1 second
key to navigate to
Allowing access for application programming using digital and
analog inputs and outputs
Providing local control and monitoring of the drive using the
Keypad
and menus. Refer to Chapter
E
0.02. Press the key to
REMOTE
LOCAL
HOLD
HOLD