Table of Contents
Advertisement
8. Installation
An I/O connection kit for building harnesses for the CM2904 is available from Parker.
I
NFORMATION
The kit includes mating connector plugs and socket contacts for connecting one
CM2904 module. The part number for the kit is 88JCM2904K2. Please consult your
Parker Account Representative for specific details and pricing information.
8.1. Installing into vehicle
Because every system is different, it is difficult for us to provide specific instructions
on how to install a CM2904 into a vehicle. Instead, we have provided mechanical,
environmental, and electrical guidelines and requirements that you should be aware
of before installing the product.
The vehicle manufacturer is responsible for creating procedures for mounting the
CM2904 in a vehicle during production assembly.
The CM2904 primary mounting location is in the vehicle's cab. If module is installed
8.1.1.
Selecting a Mounting Location
to chassis, then suitable outer enclosure shall be considered, depending on required
IP classification.
Refer to section 11 Summary of Tests for a complete list of environmental tests the
CM2904 has been tested against.
Before mounting the CM2904, ensure you review the following environmental and
mechanical requirements.
Do not install the CM2904 close to any significant heat sources, such as a turbo,
N
OTICE
exhaust manifold, etc. Also avoid installing the CM2904 near any drive-train
component, such as a transmission or engine block.
8.1.1.1.
Environmental Requirements
The CM2904warranty does not cover damage to the product when exposed to
N
OTICE
environmental conditions that exceed the design limitations of the product.
Review the following environmental specifications before selecting a mounting
location for the CM2904:
The CM2904 must be in an environment that is within its ambient
temperature range.
•
CM2904 Instruction Book
© 2009 - 2022 Parker-Hannifin Corporation
Installation
Installing into vehicle
Page 35 of 51
Advertisement
Table of Contents
