Firmware Processor (Fp) Card; Line And Trunk (Lt) Cards; Analogue Station - NEC SOPHO 2000 IPS User Manual

11

4.7 Firmware Processor (FP) Card

Firmware processors (FP) are required when more than 2 PIMs are used. For a 1 or 2 PIM
configuration a Firmware processor is not required as this is standard available
functionality on the SPN-CP24B and SPN-CP27A.
The firmware processor provides supervision and status analysis of Line/Trunk (LT) ports
that reside in the PIM. The FP card is installed in slot 12 of PIM 2, 4 and 6.
For the IPS DMR the maximum configuration consists of 2 PIMs.
The FP card is installed in slot 12 of PIM 2 of a DM
The following firmware processor is available for the SOPHO 2000 IPS/DM
12NC
960051151243

4.8 Line and Trunk (LT) Cards

Line / Trunk (LT) cards are listed in the following sections, LT cards resides directly
under the control of the FP of the associated PIM. The following conditions apply (2000
IPS):
 Max. 512 ports per system
 Max. 64 ports per PIM
 Max.128 ports per FP
The number of allowed LT ports is controlled by licenses.

4.8.1 Analogue station

Cards for analogue lines:
UNIVERGE NEAX 2000 IPS General Description
Issue 5
It's a small world
Description
SPN-CP32 FP (PBC) X X - FIRMWARE PROCESSOR
• Required when 3 or more PIM's are mounted
• DM = Max 1 card per system, mounts in third PIM
(PIM 2).
• IPS= Max 3 cards per system, One each mounts in
third PIM (PIM 2), fifth PIM (PIM 4) and seventh PIM
(PIM 6).
CHAPTER 3 TERMINALS
Not Available
Function
Page 94