Table of Contents
Advertisement
Circuit Card Mounting Slots
VM
: PZ-VM00/VM00-M/VM03-M mounting slot
LT00-LT10
: Line/Trunk card mounting slots
AP00-AP10
: Application Processor card mounting slots
LT11-AP11
: Line/Trunk/Application Processor card/PN-CP27 (MP1) backup CPU
mounting slots
MP12
: PN-CP24/ PN-CP27 (MP0) with backup CPU mounting slot
FP12
: PN-CP15 mounting slot
PFT
: PZ-8PFTB mounting slot
AC/DC PWR : PZ-PW121/PW126 mounting slot
When using the A361 PIM-DC (PIM for –48 V DC power supply
system), this slot is used for DC/DC PWR (PZ-PW135 mounting slot).
DC/DC PWR : PZ-PW122 mounting slot
When using the A361 PIM-DC (PIM for –48 V DC power supply
system), this slot is not used.
Notes
(*1) PN-CP24 (MP) card is to be mounted in the MP12 slot of PIM0. PZ-
M606-A (ETHER) card is to be mounted on the PN-CP24 (MP) card.
PN-CP15 (FP) card is to be mounted in the FP12 slot of PIM2, 4, 6
according to the system con-figuration.
(*2) Either line/trunk cards or application processor cards can be mounted
in the LT00/AP00-LT1 1/ AP11 slots of PIM0-7. For mounting condition
of PN-RTA (RTA), refer to the In-Skin Router Installation Guide.
(*3) When using PIM for –48 V DC power supply system, the AC/DC
PWR slot is used for the DC/DC PWR slot. And the DC/DC PWR slot is
not used. The other slots can accommodate the same cards as a usual
PIM.
NEC Philips Unified Solutions
Reproduction in whole or in part is prohibited without the written consent of the copyright owner.
UPD
© NEC Philips Unified Solutions, 2006. All right reserved.
CHAPTER 3 TERMINALS
254 of 259
Advertisement
Table of Contents
