Table of Contents
Advertisement
General Product Description
2.2.3 19 inch Rack-mounting Installation
2.3 Modules and Installation Hardware
2.3.1 Port Interface Module (PIM)
The SOPHO 2000 IPS is comprised of up to 8 Port Interface Modules (PIMs).
A PIM provides 13 card slots for common control, Line/Trunk (LT), and Application
Processor (AP) cards. It also houses an AC/DC Power Supply, DC/DC Power Supply (for
-48V), and batteries for protection from short-term (about 30 min.) power interruption.
Four champ connectors for Line/Trunk (LTC 0 to 3) are located at the lower front side of
the PIM. A PIM provides a maximum of 12 card slots for Line/Trunk (LT) and
Application Processor (AP) cards. At maximum configuration, the system is comprised of
8 PIMs.
There are two types of PIM depending on the system type as follows:
- PIMMJ is normally used in every PIM, but
- PIMMK is only used in PIM0 in a dual system instead of PIMMJ
NEC Philips Unified Solutions
Reproduction in whole or in part is prohibited without the written consent of the copyright owner.
Sopho 2000IPS
The SOPHO 2000 IPS can be mounted in
the IEC-standard 19 inch rack up to four
PIMs. (IEC: International Electro-technical
Commission)
UPD
© NEC Philips Unified Solutions, 2006. All right reserved.
Release 12.2, August 2006
33 of 259
Advertisement
Table of Contents
