Table of Contents
Advertisement
General Product Description
If the network is short of the requirement, it may cause the delay operation of system,
the delay and deterioration of voice packets, disconnection of calls, and frequent
changeover to survival mode at Remote Site.
-
This feature is available in the Retrofit System (used as Main Site). The system that
using the following MP cards can be mixed used in Remote PIM over IP system in
any combination.
Main Site: PN-CP24, PN-CP27, PN-CP26, PN-CP28
Remote Site: PN-CP31, PN-CP24, PN-CP26
NOTE: PN-CP27-A/PN-CP28-A cannot be used as Backup CPU system in Remote
Site.
-
This feature is not compatible with Fusion service of SV7000 (and 2400 IPX).
Conditions for System Configuration
The number of Remote Sites is a maximum of 30.
The total number of FP/AP at Main Site and all Remote Sites should not
exceed 64 including the MP built-in FP, Virtual FP, and Virtual IPT.
The number of FP/AP accommodated at one Remote Site should be a
maximum of eight including the MP built-in FP.
Remote Site can accommodate the following FP/AP/LT cards.
FP: One MP built-in FP and two Virtual FP
AP: BRT, 24DTI, 24PRT (ISDN-PRI)
LT: 8IPLA, DLC, LC, COT, ODT
NOTE: Attendant Console, Desk Console, Add-On Module, are not mountable at
Remote Site.
Remote Site cannot accommodate the following FP/AP/LT cards.
FP: FP card (CP15) is not mountable at Remote Site.
AP: AP00 (SMDR), AP00 (DBM), ICH, CCH, DCH (ISDN/Q-
SIG/Q931a), 4RSTB (MFC/T1-ANI/E911), 4RSTC/D (Caller ID trunk),
CFTC (32-party conference), IPT
LT: 8RSTG (PBR), ILC (ISDN Terminal), 4RSTF (Caller ID station),
CFTA/B (6/10-party conference), PN-8LCAD (LLC), PN-4LLCB (LLC),
PN-8PFTB (PFT), 4VCT, DK00, DAT
NOTE: Four-line built-in PBR on the MP card is available at Remote Site.
MP built-in FP must be set to each Remote Site.
The port for FP card/MP built-in FP must be assigned with every 8 port. If
the assignment value cannot be divided by 8, the value that the remainder is
omitted is assigned to the FP card/MP built-in FP automatically.
The available IP-PAD card in the Remote Site is PN-8IPLA.
For the system capacity of ISDN system or CCIS system, refer to the
system capacity of each system manual. Set the whole Remote PIM over IP
system within the system capacity and be sure to mount the handler card in
the Site where the interface card is installed.
The number of ports accommodated at one Remote Site should be a
maximum of 256. This is the sum of maximum 128 physical ports (one built-in
FP), maximum 128 IP ports (two Virtual FP), and AP ports such as ISDN, etc.
Conditions for Survival Mode at Remote Site
NEC Philips Unified Solutions
Reproduction in whole or in part is prohibited without the written consent of the copyright owner.
Sopho 2000IPS
UPD
© NEC Philips Unified Solutions, 2006. All right reserved.
Release 12.2, August 2006
53 of 259
Advertisement
Table of Contents
