Digital Announcement; Relay; Ip-Pad - NEC SOPHO 2000 IPS User Manual

4.8.7 Digital Announcement

12NC
960051150115

4.8.8 Relay

12NC
960051151203

4.8.9 IP-PAD

The following cards provide a Packet Assemble/Disassemble (PAD) gateway from and to
the IP network from the legacy interfaces in the system (TDM based interfaces). Besides
the conversion function on 32IPLAA IP-PAD C card the system can provide compression
protocols via the adjacent 16VCTAA IP-PAD A card, a maximum of 2 VCT cards can be
applied per IP-PAD.
12NC
960051151257
960051002513
UNIVERGE NEAX 2000 IPS General Description
Issue 5
Description
PN-4DATC
Description
PN-DK00
Description
SPN-32IPLAA IP PAD-C
SPN-32IPLAA IP PAD-E
X X - 4 Circuit Digital Announcement Trunk
(120 Seconds Per Channel)
X X - 8-circuit External Relay Control/External Key Scan
Card
• Provides the above-mentioned control functions on a
per circuit basis.
upto
X X X 32-channel IP-PAD Card
8
• Provides Packet Assembly/Disassembly to
accommodate Legacy Line/Trunk interface.
• 16VCT is not required when G.711 (64K) Voice
Compression is used.
• Used with a maximum of two 16VCT cards when
G.723.1, G.729a Compression is required
• Two cards can be accommodated per built-in FP/FP
card, a maximum of eight per system.
• 100 BASE-TX twisted pair cable is connected directly
to this card.
9 X X X 32-channel IP-PAD Card
upto
Provides a choice to set "100Mbps/full duplex
11
mode(fixed)", in addition to "Auto Negotiation".
Provides FAX over IP with:
- G.711 pass through (without 16VCT card)
- G.726 pass through (with SPN-16VCTAA IP PAD-B)
New Firmware
CHAPTER 3 TERMINALS
Function
Function
Function
Page 100