Table of Contents
Advertisement
General Product Description
2.14.2 SOPHO IPS DML/ IPS DMR Modular Chassis (MC)
The SOPHO 2000 IPS DML/IPS DMR consists of from one to two Modular Chassis
depending on the system configuration. There are 2 types of Modular Chassis; "Physical
Modular Chassis" and "Virtual Modular Chassis ".
The Physical Modular Chassis is "hardware Modular Chassis" and is used to
accommodate an MP, IP PADs, legacy LT/AP cards, and power supply units. The
Physical Modular Chassis provides 56 LT ports in hardware slots and provides 64 ports in
software port allocation (56 LT ports and 8 virtual ports). One Modular Chassis provides
8 card slots including one card slot for Main Processor (MP) and other 7 slots for Line
Trunk (LT)/Application Processor (AP) cards; 56 LT ports and 8 virtual LT ports; AC,
LTC, BUS cable connectors and power switch which are located at the rear side of
Modular Chassis. The Physical Modular Chassis can be installed on the desktop or into
the 19-inch rack only.
The Virtual Modular Chassis is a "software Modular Chassis" with a port capacity of 64
ports. A maximum of two Virtual Modular Chassis can be assigned per IPSD ML/IPS
DMR for a total of 128 ports used to accommodate IP stations by system data
programming.
The SOPHO IPS DML is an SOPHO 2000 IPS DM that has been optimized for Small
Office Stand Alone IP Solution with from 10 to 80 IP telephones. The SOPHO IPS DML
uses the SPN-CP31 as the Main Processor. This system targets users with up to 112 TDM
station, 128 IP stations and can be used as an end point in a peer-to-peer CCIS network.
The following options that are built-in on the CP24 are not available with the CP31:
-
No built-in DAT
-
Only one RS Port
-
No built-in DK (external/relay key)
-
No MN Alarm Indication
The SOPHO IPS DMR locates the maximum of 64 FP/AP cards per system, at multiple
Remote Sites. The number of FP/AP cards accommodated at one Remote Site should be a
maximum of eight including the MP built-in FP. If more than eight FP/APs are assigned,
the system does not operate normally. The maximum number of Remote Sites is 30. The
MP card at Remote Site has the same system data as that at Main Site, because Remote
Site automatically gets the data from Main Site at the time of setup. In normal operation,
Main Site automatically copies the system data to Remote Site through the network once
a day. Because the CP31 is a cost down CPU, the following options that are built-in on
the CP24 are not available with the CP31:
-
No built-in DAT.
-
Only one RS Port.
-
No built-in DK (external/relay key).
-
No MN Alarm Indication
The following illustration shows Modular Chassis hardware configurations, software port
allocation, face layout and rear view of Modular Chassis for The SOPHO IPS DML/IPS
DMR.
NEC Philips Unified Solutions
Reproduction in whole or in part is prohibited without the written consent of the copyright owner.
Sopho 2000IPS
UPD
© NEC Philips Unified Solutions, 2006. All right reserved.
Release 12.2, August 2006
49 of 259
Advertisement
Table of Contents
