Table of Contents
Advertisement
General Product Description
On-line Moves, Adds and Changes
When LC/DLC/COT cards are added or deleted (Moves Adds & Changes- MAC) in
Remote Site through on-line programming these cards are in real time being assigned to
the system, even if the system data copy is not activated to the Remote site.
2.15.2 Remote PIM over IP System Conditions
General Conditions
-
The same version of software must be installed in the MP cards of Main and Remote
Sites.
-
The way of loading and conditions of Key FD are following.
o The same number of Key FD for remote site license as the number of remote sites
is required for Remote PIM over IP system. The required Key FD for the whole
system must be loaded to the Main Site.
o Total number of terminals that can be accommodated in the Remote Site depends
on the number of port and number of license allocated from total Key FD data of
Main Site. The total Key FD data is loaded to Main Site and divided between
Main Site and Remote Sites as following examples.
Example 1: When 256-port Key FD is loaded to the Main Site and 64 ports are
used in the Remote Site. Remote Site: 64 ports are allocated from the
Main Site. Main Site: 192 ports are available
Example 2: When 128-IP license Key FD is loaded to the Main Site. The license
is allocated in order of connecting IP telephone regardless of Main
Site or Remote Site.
o After Key FD data is loaded to the Main Site, the service feature, number of port,
and number of license to be used by each Remote Site are sent to the flash
memory of each Remote Site's MP card automatically. When Remote Sites
operate with survival mode, this data is used.
o Data to be used by each Remote Site is stored in the flash memory every 10
minutes. When a Remote Site starts operating with survival mode within 10
minutes from starting up, the system does not operate normally because the data is
not stored in flash memory. The system should be observed for more than 10
minutes after starting up.
o The number of legacy terminal that depends on the number of PIM in TDSW
system depends on the number of port in Remote PIM over IP system. For Key
FD data, one PIM license for TDSW system is converted to 64 ports for Remote
PIM over IP system.
-
The number of accommodated terminals/trunks in Main Site and Remote Site should
be a maximum of 1020 ports in the whole system.
-
The TCP/IP network is required between Main Site and Remote Site. The closed and
bandwidth guaranteed network is preferable, such as IP-VPN (Layer 3 VPN) or wide
area Ethernet service (Layer 2 VPN). The following table shows the permissible delay
time in the network.
Recommended/
Maximum Value
Recommended
Maximum Value
NEC Philips Unified Solutions
Reproduction in whole or in part is prohibited without the written consent of the copyright owner.
Sopho 2000IPS
Permissible delay time
One-way
100 ms.
120 ms.
UPD
© NEC Philips Unified Solutions, 2006. All right reserved.
Release 12.2, August 2006
Return-way
200 ms.
240 ms.
52 of 259
Advertisement
Table of Contents
