Table of Contents
Advertisement
6.5 System Administration
In this system, the Customer Administration Terminal (CAT) or Maintenance
Administration Terminal (MAT) is used for programming the system data. The CAT is a
digital multi-function telephone (Dterm) which is equipped with function keys, a dial pad
and LCD and interfaces with the system via the MP card. The Maintenance
Administration Terminal (MAT) is a personal computer that provides an interface to the
PBX via the system CPU card. The MAT PC must have the MAT WorXTM program
properly installed to communicate with the PBX. MATWorX is required for system
software registration and activation.
Password Entry
In a system with password service, a maintenance person is required to enter an
authorization level number (Password Level) and appropriate password prior to engaging
in programming the system data with the MAT/CAT. A maximum of eight (8) Password
Levels can be set up. The number of commands that the maintenance person can access is
determined by the Password Level.
Resident System Program
This resident system program generates system data automatically according to the
system hardware configuration, thereby providing immediate operation and shorter
programming time. When activated, the system scans hardware configuration (such as
line/trunk card location) and assigns the system data (such as station numbers, trunk
numbers, etc.) according to a predetermined generic program assignment.
Service Conditions
1. This service is applicable for equipment installed in PIM0 through PIM3.
2. Data for any vacant slot is not assigned.
3. Virtual stations are not assigned.
4. A line/trunk card (PN-AUCA/PN-DK00/PN-CFTA/PN-CFTB/PN-4DAT/PN-
4RSTF/PN-4VCTI) is not assigned, even if mounted.
5. An application card is not assigned, even if mounted.
6. No tenant assignment is provided. (Tenant 01 is assigned)
6.5.1 Customer Administration Terminal (CAT)
The Customer Administration Terminal (CAT) is a digital multi-function telephone
(Dterm) which is equipped with function keys, a dial pad and LCD and interfaces with the
system via the MP card. Programming of the system can be done from selected Multiline
Terminals with LCD. The designated Multiline Terminals can be placed in program
mode, and system data can then be changed. To prevent unauthorized changes, password
levels are assigned, providing authorization for access to certain areas of programming
and denying access to others.
Service Conditions
1. Programming from a Customer Administration Terminal can only be accomplished
when the system is online.
2. All Multiline Terminals with LCD scanned during initialization will be Customer
Administration Terminals.
UNIVERGE NEAX 2000 IPS General Description
Issue 5
CHAPTER 3 TERMINALS
Page 202
Advertisement
Table of Contents
