Ccis; Q-Sig - NEC SOPHO 2000 IPS User Manual

12NC
960051151233

4.9.3 CCIS

The following cards provide the CCIS interface via point-to-point 2Mbit interface or
Common channel protocol handler. A CCIS interface requires a CCIS card software key
(license).
Use of CCIS over IP does not require additional hardware, in this case only the CCIS
Card and IPT Card software key (license) are required.
12NC
960051151286
960051151282
Note: the SPN-30CCTA-A(AP) card will be replaced by the SPN-DTA with special
firmware.

4.9.4 Q-SIG

QSIG is supported by the 2000 IPS on a Primary rate card (30B+D): SPN-30PRTA
The following features & supplementary services are supported in SW R6.2:
 Basic call (BC)
 Generic Functional Procedures (GF)
 Number identification
Calling Line Identification Presentation (CLIP)
Calling Line Identification Restriction (CLIR)
Connected Line Identification Presentation (COLP)
Connected Line Identification Restriction (COLR)
 Name identification
Calling / Connected Name Identification Presentation (CNIP)
Calling / Connected Name Identification Restriction (CNIR)
UNIVERGE NEAX 2000 IPS General Description
Issue 5
Description
SPN-SC03B 8ICH(AP)
Description
upto
SPN-30CCTA-A(AP)
SPN-SC00 CCH-D(AP)
X X - ISDN station -channel Handler Card:
• Provides the D-Channel signaling interface and
controls a maximum of four ILC cards (Layer 2 and
3).
X X - CCIS (2 Mbps) Trunk Card:
11
• Provides a built-in Common Channel Handler (CCH)
for digital 2M Point-to-Point CCIS.
X X - Common Channel Handler Card:
• Transmits/receives signals on the common signaling
channel of CCIS.
• Used with SPN-30PRTA-A(AP) to provide Event –
Based CCIS via ISDN PRI.
• Used with SPN-4BRTA-C(AP) to provide Event –
Based CCIS via ISDN BRI.
CHAPTER 3 TERMINALS
Function
Function
Page 104