Table of Contents
Advertisement
Prior to R11, 2000 IPS supports the ISDN COLP/COLR supplementary service based on
the ETSI standards. In R11 software, the IPS also supports the ISDN COLP/COLR based
on the Spanish national standards used by Telefonica.
These are now identified with the following methods:
1. ISDN-COLP/COLR (ETSI EN 300 097-1) standard ISDN Connected number
information element (IE) is part of codeset 0.
2. Spanish ISDN-COLP/COLR ISDN Connected number information element (IE) is
handled if it is part of codeset 5.
COLP: Connected Line Identification – Presentation
COLR: Connected Line Identification – Restriction
Required Hardware:
-
SPN-4BRTA-F (AP)
-
SPN-30PRTA-D (AP)
SMDR/PMS interface on IP (R9)
SMDR on IP: SMDR in R9 now has the ability to transmit over TCP/IP via the built-in
AP00 function on the CPU (on IP port of the MP card, M606A). Only one connection is
allowed using port 60010. Once the SMDR over IP function is enabled the associated RS
port on the CPU is disabled and cannot be used for any other function. Also, call records
are sent to the external SMDR device, requested by the SMDR device. Max. 1024 call
records are stored in the MP.
-
In a Remote PIM configuration, the SMDR device must be connected to the Main site.
-
In case of CCIS Centralized Billing, the SMDR on IP can be used at a center office,
but not at a local office. In this case, the center office sends the call records from the
local office to the SMDR device when received. (Not wait for receiving the request
from the SMDR device)
PMS on IP: PMS in R9 now has the ability to transmit over TCP/IP via the built-in AP00
function on the CPU (via IP port of the MP card, M606A). Only one connection is
allowed using port 60050. When using PMS over IP an AP00 cannot be used in the
system. The IP interface is compatible with model 90/120 message specifications.
-
Hotel/Motel printer cannot be used when the PMS on IP is used.
-
Check-in/Check-out cannot be set/cancel from Dterm-Hotel/Motel Front Desk
Terminal.
-
In a Remote PIM configuration, the PMS must be connected to the Main site.
Required Software and Hardware:
-
PZ-M606-A
Station Speed Dialing
This feature allows a station user to dial frequently called numbers by dialing an access
code and an abbreviated code, or by depressing a feature key or line key assigned for
Station Speed Dialing capability.
Station Speed Dialing with Account Code (R11)
Prior to R11, One-Touch Keys on Dterm can store station numbers or trunk access code +
outside telephone numbers. In R11 software, Account Code, Forced Account Code or
Authorization Code can also be programmed on the One-Touch Keys.
E.g.:
UNIVERGE NEAX 2000 IPS General Description
Issue 5
CHAPTER 3 TERMINALS
Page 172
Advertisement
Table of Contents
