NEC SOPHO 2000 IPS User Manual page 152

CHAPTER 3 TERMINALS
E&M TIE LINES
The SOPHO 2000 IPS supports both 2 and 4-wire, Type I and Type V, E&M Tine Line
connection to other SOPHO IPS systems. An ODT (Outbound Dialing Trunk) card is
required for 2 or 4-wire E&M Tie Line interface. When using a 2-wire application, one
ODT card supports two Tie Lines. When using a 4-wire application, one ODT card
supports one Tie Line. The SOPHO 2000 IPS supports a maximum of 256 trunks.
Elapsed Call Timer
This feature provides a display of the elapsed time while a Multiline Terminal with LCD
is connected to any trunk.
Enhanced 911
This feature allows the PBX to transmit a caller's emergency service identification
information to an Enhanced 911 Emergency system. The 911 notification is also provided
to the EMG key of a designated Attendant Console/Dterm.
Executed Task Printout for MP-PMS (R11)
Enable AP00 to print out executed records for Wake Up call, Do Not Disturb etc. by
coordination with PMS LAN interface
Executive Calling
This feature allows a station to be assigned a VIP class. This provides special ringing to a
called station when that station is idle, and automatic sending of three tone bursts to a
called station when that station is busy, provided the call was originated from a station
assigned as VIP class.
Executive Override
This feature allows selected users to override a busy condition on a called station. A
warning tone is transmitted to both stations in the busy call before the busy condition is
overridden, and a three-party Conference is then established.
External Paging with Meet-Me
This feature allows a station user or attendant dial-access to local voice paging equipment
and connects both parties automatically after the paged party has answered the page by
dialing an access code.
External Paging with Meet-Me over Tie Line (R12.2)
Prior to R12.2, the External Paging with Meet-Me feature is available in a standalone
configuration. Now, in R12.2 software, this feature is also available over tie line network.
A station or an operator can dial-access to voice paging equipment located in another
PBX connected via tie line trunk and connects both parties automatically after the page
party has answered the page by dialing an access code.
Available tie line trunk type is 4ODT (2-wire/4-wire E&M trunk), E1 trunk and CCIS
trunk (These trunks must support release signal sending).
Available paging trunk (external voice paging equipment interface) type is 4ODT and
8COT.
UNIVERGE NEAX 2000 IPS General Description Page 152
Issue 5