Table of Contents
Advertisement
General Product Description
2.3.2 Battery Module (BATTMH)
The BATTMH is an optional module for installing optional long-term (about 3 hours)
backup batteries. The BATTMH is designed to accommodate batteries covering up to one
stack of a 4-PIM system (2 BATTMHs support maximum system configuration).
The BATTMH is available for Floor Standing Installation. When the system is Wall-
mounting/19 inch Rack-mounting configuration, the BATTMH cannot be installed with
the PIM.
2.3.3 Installation Hardware
Base/Top Assembly
(1 per stack)
Hanger Assembly
(1 per PIM)
19 inch Bracket
(A: 1 per PIM)
(B: 1 per stack)
Mounting Bracket
(Optional 1 per stack)
I/F Bracket
(Optional 1 per
system)
Base Tray Assembly
(Optional 1 per stack)
NEC Philips Unified Solutions
Reproduction in whole or in part is prohibited without the written consent of the copyright owner.
Sopho 2000IPS
The Base/Top Assembly includes a Base Unit and a Top Cover
for the PIM. One Base/Top Assembly is required for each PIM
stack. The Base Unit also serves as the AC power distribution
panel for up to a four PIM configuration.
The Hanger Assembly is used for Wall-mounting Installation.
One set of Hanger Assembly is required for each PIM.
The 19-inch Bracket is a set of hardware used for 19-inch
Rack-mounting Installation.
The 19-INCH RACK BRACKET (A) is installed on both sides
of the PIM. One set of 19 inch Bracket (A) is required for each
PIM.
The 19-INCH RACK BRACKET (B) is installed at the BASE
of stack. One 19-INCH BRACKET (B) is required for each
stack.
If the system is 2 PIM or more configurations with 19-INCH
BRACKET (B), one set of 19-INCH BRACKET (A) is also
required for the topmost PIM.
This is used for Floor Standing Installation. Without Mounting
Bracket, 1.1 G shockproof is provided for 1 to 3-module stack
and 0.5G shockproof is provided for 4 or more module stack.
To enhance the shockproof capability to 1.1 G, one set of
Mounting Bracket is required for each 4 or more module stack
and attached to the topmost PIM.
This is used for Floor Standing Installation to joint the
neighboring topmost PIM in 6 PIM or more configurations.
One set of I/F Bracket is required for multiple stacks.
This is used for Floor Standing Installation for stationary
equipment (UL complied). One set of Base Tray Assembly is
required for each stack.
UPD
© NEC Philips Unified Solutions, 2006. All right reserved.
Release 12.2, August 2006
34 of 259
Advertisement
Table of Contents
