To Set Up Time Correlation Between Two State Analyzers - Agilent Technologies 1670G Series User Manual

Logic analyzers

Hide thumbs Also See for 1670G Series:

Table of Contents

Using the Trigger Menu

Setting Up Time Correlation between Analyzers

To set up time correlation between two state

To correlate the data between two state analyzers, both must have

Count Time turned on in their Trigger menus. Although both have

Count State available, it is not possible to correlate data based on

states even when they are identically defined.

1 In the Analyzer Trigger menu, select Count.

Count may be Count Off, Count Time, or Count States. Selecting the

field causes a pop-up to appear.

2 Select the field after Count: and select Time.

A warning may appear about reduced memory. It will not prevent you

from changing Count to Count Time.

3 Select Done.

4 Repeat steps 1 through 3 for the other state analyzer.

Now when you acquire data you will be able to interleave the listings.

Troubleshooting