Cross-Arming Trigger Examples - Agilent Technologies 1670G Series User Manual

Logic analyzers

Hide thumbs Also See for 1670G Series:

Table of Contents

Triggering Examples

Cross-Arming Trigger Examples

The following examples use cross arming to coordinate measurements

between two separate analyzers within the logic analyzer or between

analyzers and the oscilloscope. The analyzers can be configured as

either a state analyzer and timing analyzer, or two state analyzers. It is

not possible to set both to timing.

You set up cross arming in the Arming Control menu (obtained by

selecting Arming Control in the Trigger menu). When coordinating

measurements between two instruments, you need to select Count

Time to correlate the measurements. When correlating measurements

between an analyzer and the oscilloscope you also need to set the

oscilloscope Trigger Mode to Immediate.