To Copy Ascii Measurement Data - Agilent Technologies 1670G Series User Manual

Logic analyzers

Hide thumbs Also See for 1670G Series:

Table of Contents

1 Set up the measurement you want to make, and run the analyzer

2 Access the logic analyzer's file system.

3 Copy the measurement data from the \slot_a\data.asc

To copy ASCII measurement data

to acquire data.

For more information on setting up measurements, see the

Logic Analyzer section of this book.

Refer to the chapter "Accessing the Logic Analyzer File System".

You can do this from the XWindow interface, your computer using NFS

or ftp, from the front panel, or by programming the logic analyzer.

subdirectory.

In the analyzer's file system, ASCII data files are located in

\slot_a\data.asc\{analyzer name}\{label name}.txt.

There is an ASCII data file corresponding to each label name you have

created in the measurement module. The data files for each label are

overwritten by the analyzer each time new data is acquired.

1670G-Series with the oscilloscope option only

Oscilloscope data is under \slot_b\data.asc. There is no subdirectory matching

{analyzer name} but there are files for both oscilloscope channels.

Retrieving and Restoring Data Using the LAN