Agilent Technologies 1670G Series User Manual page 502

Logic analyzers

Hide thumbs Also See for 1670G Series:

Table of Contents

Using the LAN's X Window Interface

Pseudo telnet method using a UNIX computer

To enable windows to be initiated from the logic analyzer named

lp1670G, enter the following command on the computer running the

xhost +lp1670G

To connect to the command parser socket of the logic analyzer named

lp1670G, enter:

telnet lp1670G 5025

Agilent Technologies logic analyzers are not telnet servers. The UNIX

command telnet is used to make a connection to the analyzer command

parser, which uses socket number 5025. A telnet server would normally not

need to have the socket specified.

To start the XWindow interface on the computer whose IP address is

15.6.253.146 (and is running the Xserver) enter:

xwin on,"15.6.253.146:0.0"

If you are not planning on sending more commands to the logic

analyzer, close the telnet connection by typing the escape character,

and then "quit" when the telnet prompt appears. The escape character

is often Control-]; your telnet program should tell you when it opens

the connection.

Troubleshooting