To Connect To An Rs-232-C Printer - Agilent Technologies 1670G Series User Manual

Logic analyzers

Hide thumbs Also See for 1670G Series:

Table of Contents

To connect to an RS-232-C printer

1 Turn off the analyzer and the printer, and connect a null-modem

RS-232-C cable from the printer to the RS-232-C connector on

the analyzer rear panel.

2 Before turning on the printer, locate the mode configuration

switches on the printer and set them as follows:

• For the HP QuietJet series printers, there are two banks of mode

function switches inside the front cover. Push all the switches down to

the 0 position.

• For the HP ThinkJet printer, the mode switches are on the rear panel of

the printer. Push all the switches down to the 0 position.

• For the HP LaserJet printer, the factory default switch settings are

3 Turn on the analyzer and printer.

4 Go to the System External I/O menu and configure the analyzer's

printer settings.

a If the analyzer is not already set to RS232, select the field

under Connected To: in the Printer box and choose RS232

from the menu.

b Select the Printer Settings field.

c In the top field of the pop-up, select the type of printer you

are using. If you are using an Epson graphics printer or an

Epson-compatible printer, select Alternate.

Connecting Peripherals