To Restore Configurations - Agilent Technologies 1670G Series User Manual

Logic analyzers

Hide thumbs Also See for 1670G Series:

Table of Contents

1 Access the logic analyzer's file system as the control user.

2 Copy the setup.raw file to the appropriate directory.

Retrieving and Restoring Data Using the LAN

To restore configurations

Refer to the chapter "Accessing the Logic Analyzer File System".

For system configurations, this would be the \system directory. For

analyzer configurations, this would be the \slot_a directory. For

oscilloscope configurations, it would be the \slot_b directory. If you

copy a configuration file to a different directory than it came from, the

analyzer will not know how to interpret it.

Restoring an analyzer configuration

Suppose you want to load a configuration file called "486_bus" from

your local computer into the logic analyzer's analyzer. The analyzer is

always in slot A. The logic analyzer is mounted on your network as disk

To load the configuration file, at the MS-DOS prompt enter:

copy 486_bus L:\slot_a\setup.raw

If your computer is running the UNIX operating system, you might use

the cp command. In an MSWindows environment, you can use File