Agilent Technologies 1670G Series User Manual page 57

5 If additional Symbols are needed, repeat step 4 until you have
6 Toggle the Type field to "range" or "pattern".
7 Select the Pattern/Start field and use the keypad to enter an
8 When the pattern is specified, press Done. If you created
9 To close the symbol table menu, select Done.
See Also
added all symbols.
In this example, three symbols are added: MEM RD, MEM WR, and
DATA RD.
When Type is range, a third field appears under the Stop column. To
fully specify a range, you need to enter a value for it, too.
appropriate value in the selected base. Use X for "don't care."
additional Symbols, repeat steps 6 and 7 until all symbols are
specified.
Symbol table Menu Showing Three Symbols
You can also download symbol tables created by your programming
environment using the Symbol Utility. The Symbol Utility is shipped
installed on all 1670G-series logic analyzers.
The Symbol Utility section of this book on page 565 for more
information on the Symbol Utility.
Using the Logic Analyzer
Using the Analyzer Menus
57