Connecting The Pattern Generator Pods Directly To A Pc Board (Pattern Generator Option Only) - Agilent Technologies 1670G Series User Manual

Logic analyzers

Hide thumbs Also See for 1670G Series:

Table of Contents

Logic Analyzer Reference

Connecting the pattern generator pods directly

to a PC board (pattern generator option only)

To connect the pattern generator pods directly to the PC board, use

one of the following two methods. Both methods require that a 3M

2520-series, or similar alternative connector be installed on the PC

Direct pod to board connection

Simply plug the pod directly into the 3M 2520-series, or similar

alternative connector on the PC board.

Jumper cable to pod connection

Use this method when you have clearance problems on the PC board.

Construct a flat ribbon cable and connect as shown below.

Equivalent connectors can be obtained from sources other than 3M.

Troubleshooting