1MRK 506 334-UUS A
5.1.4.2
5.1.4.3
Application manual
Table 6:
Alarm indications
LED state
Description
Off
Normal operation. All activation signals are off.
On
•
Follow-S sequence: The activation signal is on.
•
LatchedColl-S sequence: The activation signal is on, or it is off but the indication has
not been acknowledged.
•
LatchedAck-F-S sequence: The indication has been acknowledged, but the activation
signal is still on.
•
LatchedAck-S-F sequence: The activation signal is on, or it is off but the indication has
not been acknowledged.
•
LatchedReset-S sequence: The activation signal is on, or it is off but the indication has
not been acknowledged.
Flashing
•
Follow-F sequence: The activation signal is on.
•
LatchedAck-F-S sequence: The activation signal is on, or it is off but the indication has
not been acknowledged.
•
LatchedAck-S-F sequence: The indication has been acknowledged, but the activation
signal is still on.
Parameter management
The LHMI is used to access the IED parameters. Three types of parameters can be read and
written.
•
Numerical values
•
String values
•
Enumerated values
Numerical values are presented either in integer or in decimal format with minimum and
maximum values. Character strings can be edited character by character. Enumerated
values have a predefined set of selectable values.
Front communication
The RJ-45 port in the LHMI enables front communication.
•
The green uplink LED on the left is lit when the cable is successfully connected to the
port.
Local human-machine interface
Section 5
111