Setting Guidelines - ABB REL650 Applications Manual

1MRK 506 334-UUS A
13.3.3
13.4
13.4.1
Application manual
TMAGGIO 3 output signals and the physical outputs allows the user to adapt the signals
to the physical tripping outputs according to the specific application needs for settable
pulse or steady output.

Setting guidelines

Operation: Turns the operation of the function Enabled/Disabled.
PulseTime: Defines the pulse time duration. When used for direct tripping of circuit
breaker(s) the pulse time duration shall be set to approximately 0.150 seconds in order to
obtain satisfactory minimum duration of the trip pulse to the circuit breaker trip coils.
Used only for ModeOutputx: Pulsed.
OnDelay: Used to prevent output signals to be given for spurious inputs. Normally set to
0 or a low value. Used only for ModeOutputx: Steady.
OffDelay: Defines a minimum on time for the outputs. When used for direct tripping of
circuit breaker(s) the off delay time shall be set to approximately 0.150 seconds in order
to obtain a satisfactory minimum duration of the trip pulse to the circuit breaker trip coils.
Used only for ModeOutputx: Steady.
ModeOutputx: Defines if output signal OUTPUTx (where x=1-3) is Steady or Pulsed. A
steady signal follows the status of the input signals, with respect to OnDelay and
OffDelay. A pulsed signal will give a pulse once, when the Outputx rises from 0 to 1.
Configurable logic blocks
Identification
Function description
OR Function block
Function description
Inverter function block
Function description
PULSETIMER function block
IEC 61850 IEC 60617
identification identification
OR -
IEC 61850 IEC 60617
identification identification
INVERTER -
IEC 61850 IEC 60617
identification identification
PULSETIMER -
Section 13
Logic
ANSI/IEEE C37.2
device number
-
ANSI/IEEE C37.2
device number
-
ANSI/IEEE C37.2
device number
-
419