Fastening The G450 To The Wall; Placing The G450 On A Table; Step 2: Installing The Power Supply Units - Avaya G450 Installing And Upgrading

Figure 4: Attaching a bracket to each side of the G450

Fastening the G450 to the wall

The plywood and the hardware to mount the plywood are installer-provided.
1. If the wall does not have a portion of plywood available, mount a plywood sheet at least
½ in (1.2 cm) thick and at least 2 x 2 ft (0.6 x 0.6 m) in size, horizontally onto the wall.
Make sure the plywood screws are sufficiently anchored in the wall. Use a minimum of four
wood screws and ensure the screws are driven into wall studs, or use four wall anchors
rated not less than 50 pounds (22.5 kg) shear strength each.
2. Mark the plywood with the location of the G450 bracket screw holes before fastening the
plywood to the wall.
3. Position the G450 so that its front panel is facing up, and secure it to the plywood using a
minimum of four screws (pan head at least ½ in, # 10-12 screw).

Placing the G450 on a table

If you will be installing the G450 as a tabletop unit, you need to affix the provided rubber feet to
the underside of the G450.
1. Remove the four feet from their packaging.
2. Turn the G450 upside down.
3. Position each foot into one of the mounting sites, near each corner of the chassis.

Step 2: Installing the Power Supply Units

When the G450 chassis is installed, first insert the power supply unit(s) if you removed them
before installation (refer to Removing power supply units
Step 2: Installing the Power Supply Units
on page 27).
Issue 2 June 2008 33