Chapter 5: Configuring the G450
The G450 requires software configuration. The G450 can be configured using:
The Avaya Installation Wizard (Avaya IW). Avaya IW is a wizard that prompts you for all
●
configurations required to complete the installation of the G450. Avaya IW is used only to
configure a G450 with an S8300. Refer to
Wizard (Avaya IW)
The Gateway Installation Wizard (GIW). The GIW is a wizard that prompts you for all
●
configurations required to complete the installation of the G450. You can run GIW to
configure a G450 without an S8300. Refer to
Installation Wizard (GIW)
The Avaya G450 Command Line Interface (CLI). The CLI is a comprehensive tool for
●
configuring the gateway and includes all supported configuration tasks. For information
about configuration using the CLI, see Administration for the Avaya G250 and Avaya G350
Media Gateways, 03-300436. For detailed information on CLI commands, refer to the
Avaya G350 CLI Reference, 03-300437.
The G450 can be configured at the customer site via a laptop connected to the CON port or
Services port of the G450, or from a remote location via a modem. For information about
connecting a laptop to the Services port, refer to
page 48. For information about connecting and enabling a modem, refer to
Chapter 4: Connecting and enabling a modem for remote access
on page 151.
on page 209.
Appendix C: Running the Avaya Installation
Appendix D: Running the Gateway
Connecting a computer to the Services port
on page 63.
on
Issue 2 June 2008
81