Step 2: Removing The Installation Equipment - Avaya G450 Installing And Upgrading

Table 5: IP addresses and controllers
Primary media
gateway controller
S8300
S8400
S8500
S8710
S8720
S8730

Step 2: Removing the installation equipment

Remove all equipment that you used to assist you in the installation process. This may include
the CD-ROM drive, the software upgrade CDs, the laptop computer, and the modem (for
installations without an S8300 module only).
Note:
If you have an S8300 Server module installed in the G450, leave the modem
Note:
connected to enable reporting of alarms to remote locations.
IP addresses to configure
The IP address of the primary S8300
The IP address of the S8400's C-LAN or the IP address
of an Ethernet port on the S8400 configured for
processor Ethernet connections
The IP address of the S8500's C-LAN or the IP address
of an Ethernet port on the S8500 configured for
processor Ethernet connections
The IP address of the S8710's C-LAN and the IP
address of alternate C-LAN boards connected to the
S8710
The IP address of the S8720's C-LAN and the IP
address of alternate C-LAN boards connected to the
S8720
The IP address of the S8730's C-LAN and the IP
address of alternate C-LAN boards connected to the
S8730
Step 2: Removing the installation equipment
Issue 2 June 2008 85