Avaya G450 Installing And Upgrading page 217

Figure 129: The SNMP V3 screen
23. If you want to configure an SNMP V3 user on the G450:
a. In the User Name field, enter a string of up to 32 characters representing the SNMP
V3 user.
b. In the Authentication Protocol field, select the authentication protocol by which the
SNMP V3 user should be authenticated (SHA1 or MD5).
c. In the Authentication Password field, enter a string of between 8 and 64 characters
specifying the user's authentication password. The authentication password is
transformed using the authentication protocol and the SNMP engine ID to create an
authentication key.
d. In the Re-enter Authentication Password field, enter the authentication password
again for verification.
e. In the Privacy Password field, enter a string of between 8 and 64 characters
specifying the SNMP V3 user's privacy password.
f. In the Re-enter Privacy Password field, enter the privacy password again for
verification.
24. Click Continue. The IP Addresses - Media Gateway Controller List screen appears.
Running the Gateway Installation Wizard (GIW)
Issue 2 June 2008 217