Mounting The G350 On A Wall - Avaya G350 Installing And Upgrading

To mount the G350 in the rack:
1. Position the G350 in the rack. Ensure that there is adequate ventilation.
2. Verify that the screw holes are aligned with the rack hole positions.
3. Insert two mounting screws on each side.
4. Tighten the mounting screws. Avoid overtightening.
5. Verify that ventilation vents are not obstructed.
At this point, you have mounted the G350 chassis in the rack and are ready to insert media
modules as required in the planning documentation.

Mounting the G350 on a wall

To mount the G350 on a wall, use the two mounting brackets without cable guides. If the wall is
flat, you can screw the G350 directly to the wall. If the wall is not flat, screw a plywood board
(415 x 465 mm, 20 mm thick) to the wall with wood screws, and fasten the G350 to the board.
To attach brackets to the G350 for wall mounting:
1. Attach a bracket to each side of the G350, as shown in the figure below.
Step 1: Mount the G350 chassis
Issue 3.1 June 2006 33