Configuring A Trunk Media Module; Endpoint Installation - Avaya G450 Installing And Upgrading

Configuring a trunk media module

1. To configure a trunk media module, click Continue from the IP Trunk List screen. The CO
Trunk List screen appears. Use this screen which lists trunk media modules detected in
the G450 to configure a media module and run diagnostics. To configure or run diagnostics
on a trunk media module, click the Actions icon for the module.
Figure 110: The CO Trunk List screen
2. Select an additional action from the Actions column, or click Continue to proceed to the
CO Trunk List screen.

Endpoint installation

The Endpoint section appears in the wizard only if you selected the option to use this wizard to
create basic translations in the Translation Source screen (see step 7). If you did not select the
option to use this wizard to create basic translations in the Translation Source screen, skip to
Alarm configuration
For instructions on endpoint installation, click Continue from the CO Trunk List screen. The
Endpoint Installation screen appears. You can access endpoint installation information from this
screen.
on page 198.
Firmware configuration
Issue 2 June 2008 197