Configuring Communications - Olympus 45MG User Manual

NOTE
The calibration and setup parameters are also always saved/sent along with the
thickness measurement.
7. Set DEFAULT FILE MODE to the desired default file data mode when you create
a file (see "File Data Modes" on page 104 for details).
8. Set TEXT EDIT MODE to the appropriate option for entering alphanumeric
values. The two available options are the virtual keyboard (VIRTUAL) and the
legacy character wheel selection (TRADITIONAL) [see "Selecting the Text Edit
Mode" on page 39 for details].
9. Set SCR TO SD CARD to ON to enable the 45MG to create a BMP image file on
the external microSD card for the actual screenshot when you press [2nd F],
[SETUP] (see "Sending a Screen Capture to the External microSD Card" on
page 195 for details).
10. Press [MEAS] to return to the measurement screen.
8.3

Configuring Communications

The 45MG features a USB port that can be used to connect the instrument to a
computer. When connected to a computer, the 45MG can send and receive data, or be
remotely controlled by the computer (when the Datalogger option has been
activated).The remote command document and the FTP (file transfer protocol)
document are available upon request.
Select the communication parameters you want to use.
To configure the communication parameters
1. In the measurement screen, press [SETUP], and then select COMM.
2. In the COMM screen (see Figure 8-3 on page 147):
a) In COMM PROTOCOL, select the remote command set to be used by the
instrument for communication:
• MULTI CHAR: Multi character commands that are used for
communication with a computer running the GageView interface
program.
DMTA-10022-01EN, Rev. C, January 2015
Configuring the Instrument 145