Dmta-10022-01En, Rev. C, January - Olympus 45MG User Manual

DMTA-10022-01EN, Rev. C, January 2015

• Automatic probe recognition for the standard D79X and MTD705 series
transducers
• Warning against calibration doubling (for dual element transducers)
• Calibration for unknown material sound velocity and/or transducer zero
• Fast scan mode with 20 readings per second
• Hold or blank thickness display during loss-of-signal (LOS) conditions
• Hold minimum and maximum functions
• Differential thickness display relative to the set point in absolute values or
percentage ratios
• Selection of password-protected lockout functions
• Selectable resolution: low of 0.1 mm (0.01 in.), standard of 0.01 mm (0.001 in.), or
high (optional) of 0.001 mm (0.0001 in.); [option not available for all transducers]
Optional features
• Single element transducers
• Echo-to-Echo and THRU-COAT measurements
• High Penetration software for low-frequency single element transducers
• A-scan or waveform display
— Real-time A-scan waveform display for verification of critical measurements
— Manual freeze mode with post processing
— Manual zoom and range control of waveform display
— Auto hold on loss of signal (LOS) and auto zoom (measured echo centering)
— Extended blank
— Blank after first received echo in Echo-to-Echo mode
— Receiver gain readout
— Ability to capture and display waveform associated with minimum thickness
during scanned measurements
— Display of stored and downloaded waveforms (Datalogger option only)
— Manual gain adjustment in 1-dB steps
• Internal datalogger functions
— Internal data storage and possibility to export data to a removable microSD
memory card
— Capacity to store 475000 fully-documented thickness readings or
20000 waveforms with thickness readings
18 Chapter 1