Activating And Configuring The Db Grid; Figure 9-8 Changing Db Grid Parameters; Figure 9-9 Grid Transposition Example - Olympus 45MG User Manual

DMTA-10022-01EN, Rev. C, January 2015
9.4.1

Activating and Configuring the DB Grid

Activate and configure the DB grid options from the DB GRID screen.
To activate and configure the DB grid
1. In the measurement screen, press [SETUP], and then select DB GRID.
2. In the DB GRID screen (see Figure 9-8 on page 160), perform the following steps.
3. Set DB GRID ENABLE to ON to activate the DB grid.
4. Set TRANSPOSE GRID to ON to interchange the rows and columns in a grid
(see Figure 9-9 on page 160).
TRANSPOSE GRID set to OFF
160 Chapter 9

Figure 9-8 Changing DB grid parameters

Figure 9-9 Grid transposition example

TRANSPOSE GRID set to ON