Olympus 45MG User Manual page 119

• Location note
• Delete protection (on/off)
• End row, column, or point of a grid file
• Incrementing order of a grid file
• Incrementing direction (forwards or reverse) for rows, columns, points, tube
numbers, and elevations
The edit function does not allow you to edit the file type, and cannot be used to edit
individual measurement identifiers (ID), or actual thickness readings.
To edit an existing file
1. In the measurement screen, press [FILE], and then select EDIT.
2. In the EDIT screen (see Figure 6-29 on page 110):
a) In the list, select the file you want to edit.
NOTE
When scrolling through the file names, a descriptive header for the highlighted file
name appears on the lower section of the display. This information can assist in
selecting the proper file if you are uncertain of the exact file name.
b) To rename the file, edit the NAME value.
c) Edit the file description (DESC), the inspector identification (INSP ID), and
the location note (LOC NOTE) values as needed.
d) To change the file lock state, set DELETE PROTECTION to ON or OFF.
e) For a nongrid file, select UPDATE.
DMTA-10022-01EN, Rev. C, January 2015
Software Options 109