Erasing Data In The Active File - Olympus 45MG User Manual

7. Press [SAVE] with or without an active measurement to make the edited ID a
permanent part of the database.
The sequence resumes at the previous active ID.
6.7.6.3

Erasing Data in the Active File

Data erased using the following techniques CANNOT be recovered.
To erase a single measurement
1. In the measurement screen, press [2nd F], [FILE] (ID#).
The ID review screen appears and shows the active ID with its stored data.
2. Select the ID to be erased (see "Reviewing Stored Data and Changing the Active
ID" on page 117), and then press [MEAS].
3. Press [SAVE] when not getting a reading to save "--.---", and then erase the single
reading ID.
The displayed ID changes to the next ID in the sequence.
TIP
The easiest way to replace a thickness reading is to save a new measurement at the
desired ID in the measurement screen. If you do not want to save a measurement at a
specific ID, press [SAVE] in the measurement screen when you are not taking a
measurement. This stores an LOS condition and —-.—- at the specific ID number.
4. Press [MEAS] to return to the measurement screen.
NOTE
When a measurement stored in incremental files is deleted, the ID is also deleted. In
all other file types, only the thickness and waveform data is deleted.
CAUTION
DMTA-10022-01EN, Rev. C, January 2015
Software Options 119