Config Configuration - D-Link DGS-3620-52P Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
<pathname> - Specify a firmware on the device file system.
boot_up - Specify as a boot-up file.
Restrictions
Only Administrator-level users can issue this command.
Example
To configure a firmware file to bootup:
DGS-3620-28SC:admin#config firmware image 2.00.009.had boot_up
Command: config firmware image 2.00.009.had boot_up
Success.
DGS-3620-28SC:admin#
103-10

config configuration

Description
This command is used to select a configuration file as the next boot up configuration or to apply a
specific configuration to the system.
Format
config configuration {unit <unit_id>} <pathname> [boot_up | active]
Parameters
unit – (Optional) Specifies the unit ID used.
<unit_id> - Enter the unit ID used here.
<pathname> - Specifies a configuration file on the device file system.
boot_up - Specifies as a boot up file.
active - Specifies to apply the configuration.
Restrictions
Only Administrator-level users can issue this command.
Example
To configure the specific configuration file as boot up:
DGS-3620-28SC:admin#config configuration 1 boot_up
Command: config configuration 1 boot_up
Success
DGS-3620-28SC:admin#
1044