Assembly Of Cable Terminals On The Drive Side - Siemens SINAMICS V90 Operating Instructions Manual

A.2

Assembly of cable terminals on the drive side

Power terminal assembly
Drive type
SINAMICS V90 200 V
variant:
FSA/FSB/FSC/FSD
SINAMICS V90 400 V
variant: FSAA/FSA
SINAMICS V90 400 V
variant: FSB/FSC
SINAMICS V90, SIMOTICS S-1FL6
Operating Instructions, 09/2015, A5E36037884
Procedure
Terminal assembly procedure:
1. Remove the outer sheath of the cable.
2. Remove the insulation from the wire.
3. Insert the stripped end into the cable
end sleeve.
4. Crimp the cable end sleeve using a
crimp tool for end sleeves.
Terminal assembly procedure:
1. Remove the outer sheath of the cable.
2. Remove the insulation from the wire.
3. Insert the stripped end into the spade
terminal.
4. Crimp the spade terminal using a crimp
tool for cable lugs. (Note: Coat any ex-
posed wires with tin.)
A.2 Assembly of cable terminals on the drive side
Illustration
Appendix
337