Side View - Siemens SINUMERIK 840D sl Operating Manual

Simulating machining
5.5 Different views of the workpiece
Changing the display
You can increase or decrease the size of the simulation graphic, move it, turn it, or change
the segment.
Displaying and moving cutting planes
You can display and move cutting planes X, Y, and Z.
See also
Enlarging or reducing the graphical representation (Page 164)
Panning a graphical representation (Page 165)
Rotating the graphical representation (Page 165)
Modifying the viewport (Page 166)
Defining cutting planes (Page 167)
5.5.3

Side view

Changing the display
You can increase or decrease the size of the simulation graphic and move it, as well as
change the segment.
160
1. Starting the simulation.
2. Press the "Other views" softkey.
3. Press the "From front" softkey if you wish to view the workpiece from
the front.
- OR -
Press the "From rear" softkey if you wish to view the workpiece from the
rear.
- OR -
Press the "From left" softkey if you wish to view the workpiece from the
left.
- OR -
Press the "From right" softkey if you wish to view the workpiece from
the right.
Operating Manual, 03/2013, 6FC5398-6AP40-3BA1
Universal