Safety Instructions - Siemens SINAMICS V90 Operating Instructions Manual

In addition, the safety function of SINAMICS V90 has been certified by independent institutes.
An up-to-date list of certified components is available on request from your local Siemens
office.
8.3.3

Safety instructions

Note
Additional safety information and residual risks not specified in this section are included in
the chapter "Safety instructions (Page 11)".
Safety Integrated can be used to minimize the level of risk associated with machines and
plants.
Machines and plants can only be operated safely in conjunction with Safety Integrated,
however, when the machine manufacturer is familiar with and observes every aspect of this
technical user documentation, including the documented general conditions, safety
information, and residual risks.
Precisely knows and observes this technical user documentation - including the
documented limitations, safety information and residual risks;
Carefully constructs and configures the machine/plant. A careful and thorough acceptance
test must then be performed by qualified personnel and the results documented.
Implements and validates all the measures required in accordance with the machine/plant
risk analysis by means of the programmed and configured Safety Integrated functions or by
other means.
The use of Safety Integrated does not replace the machine/plant risk assessment carried
out by the machine manufacturer as required by the EC machinery directive.
In addition to using Safety Integrated functions, further risk reduction measures must be
implemented.
The Safety Integrated functions cannot be activated until the system has been completely
powered up. System startup is a critical operating state with increased risk. No personnel
may be present in the immediate danger zone in this phase.
The drives of vertical axes must be in torque state.
A complete forced dormant error detection cycle is required after power on.
SINAMICS V90, SIMOTICS S-1FL6
Operating Instructions, 09/2015, A5E36037884
DANGER
WARNING
Safety Integrated function
8.3 System features
241