Siemens SINAMICS V90 Operating Instructions Manual page 145

Display Example
Data
Func
Jog
Save
defu
dr--sd
sd--dr
Update
A OFF1
A OFF2
ABS
A.B.S.
r xxx
r -xxx
T x.x
T -x.x
DCxxx.x
Exxxxx
Con
SINAMICS V90, SIMOTICS S-1FL6
Operating Instructions, 09/2015, A5E36037884
Description
Read-only parameter group
Function group
Jog function
Save data in drive
Restore drive to default settings
Save data from drive to micro SD
card/SD card
Upload data from micro SD
card/SD card to drive
Update firmware
Adjust AI1 offset
Adjust AI2 offset
The zero position has not been set
The zero position has been set
Actual speed (positive direction)
Actual speed (negative direction)
Actual torque (positive direction)
Actual torque (negative direction)
Actual DC link voltage
Position following error
The communication between the
SINAMICS V-ASSISTANT and the
servo drive is established.
In this case, the BOP is protected
from any operations except clear-
ing alarms and acknowledging
faults.
Basic operator panel (BOP)
Remarks
Refer to "Read a parameter value
(Page 152)".
Refer to "Function overview (Page 153)".
Refer to "Jog (Page 154)".
Refer to "Save parameters in the servo drive
(Page 155)".
Refer to "Reset parameters to default values
(Page 155)".
Refer to "Copy parameters from the servo
drive to a micro SD card/SD card
(Page 156)".
Refer to "Copy parameters from a micro SD
card/SD card to the servo drive (Page 157)".
Refer to "Update firmware (Page 157)".
Refer to "Adjust AI offset (Page 158)".
Refer to "Adjust AI offset (Page 158)".
Refer to "Set zero position (Page 160)".
Refer to "Set zero position (Page 160)".
6.1 BOP overview
145