HP HSR6800 Configuration Manual page 145

[PE2] ospf
[PE2-ospf-1] area 0
[PE2-ospf-1-area-0.0.0.0] network 10.0.0.0 0.0.0.255
[PE2-ospf-1-area-0.0.0.0] network 3.3.3.3 0.0.0.0
[PE2-ospf-1-area-0.0.0.0] quit
[PE2-ospf-1] quit
After you complete the configuration, the PEs establish an OSPF neighbor relationship.
Execute the display ospf peer verbose command. You can see that the neighborship state is
FULL. Execute the display ip routing-table command. You can see that the PEs have learned
the routes to the loopback interfaces of each other. Take PE 1 for example:
[PE1] display ospf peer verbose
OSPF Process 1 with Router ID 2.2.2.2
Area 0.0.0.0 interface 10.0.0.1(POS5/1/1)'s neighbors
Router ID: 3.3.3.3
State: Full
DR: None BDR: None
Dead timer due in 30
Neighbor is up for 00:01:00
Authentication Sequence: [ 0 ]
[PE1] display ip routing-table
Routing Tables: Public
Destinations : 7
Destination/Mask
2.2.2.2/32
3.3.3.3/32
10.0.0.0/24
10.0.0.1/32
10.0.0.2/32
127.0.0.0/8
127.0.0.1/32
2. Configure basic MPLS TE, and enable RSVP-TE and CSPF:
# Configure PE 1.
[PE1] mpls lsr-id 2.2.2.2
[PE1] mpls
[PE1-mpls] lsp-trigger all
[PE1-mpls] mpls te
[PE1-mpls] mpls rsvp-te
[PE1-mpls] mpls te cspf
[PE1-mpls] quit
[PE1] interface pos 5/1/1
[PE1-POS5/1/1] mpls
[PE1-POS5/1/1] mpls te
[PE1-POS5/1/1] mpls rsvp-te
[PE1-POS5/1/1] quit
# Configure PE 2.
[PE2] mpls lsr-id 3.3.3.3
[PE2] mpls
[PE2-mpls] lsp-trigger all
Neighbors
Address: 10.0.0.2
Mode:Nbr is Master
sec
Routes : 7
Proto Pre Cost
Direct 0 0
OSPF 10 1563
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
137
GR State: Normal
Priority: 1
NextHop Interface
127.0.0.1 InLoop0
10.0.0.2 POS5/1/1
10.0.0.1 POS5/1/1
127.0.0.1 InLoop0
10.0.0.2 POS5/1/1
127.0.0.1 InLoop0
127.0.0.1 InLoop0