Configuring The Remote Peer For A Pe; Creating A Martini Vc On A Layer 3 Interface - HP HSR6800 Configuration Manual

2. Create a VC in Martini mode, in one of the following ways:
Configure a Martini VC on a Layer 3 interface.
In this way, packets arriving at this interface are forwarded over the created VC. As a best
practice, create a VC on a Layer 3 interface when all users connected to the interface have
their packets forwarded over the same VC.
Configure a Martini VC for a service instance.
After you configure a Martini VC for a service instance applied on a Layer 2 Ethernet
interface, the interface uses the service instance to match incoming packets. Packets
matching the service instance are forwarded over the VC. A service instance can match all
packets received on the interface, packets carrying the specified VLAN tags, all tagged
packets, or packets with no VLAN tags.
Service instances can be created only on Layer 2 Ethernet interfaces. For more information
about service instances, see "Configuring VPLS."

Configuring the remote peer for a PE

Step
1. Enter system view.
2. Create remote peer entity and enter MPLS LDP
remote peer view.
3. Specify the IP address of the remote peer as
that of the peer PE.
For remote peer configuration information, see "Configuring basic MPLS."

Creating a Martini VC on a Layer 3 interface

A Martini VC has two main parameters: IP address of the peer PE, and VC ID. The combination of
the VC ID and the VC type must be unique on a PE. Changing the VC type might result in VC ID
conflicts.
To create a Martini VC on a Layer 3 interface of a PE:
Step
1. Enter system view.
2. Enter the view of the
interface connecting the CE.
3. Create a Martini VC.
4. Switch traffic from the active
VC to the standby VC.
Command
system-view
mpls ldp remote-peer remote-peer-name
remote-ip ip-address
Command
system-view
interface interface-type
interface-number
mpls l2vc destination vcid
[ { control-word | ethernet |
no-control-word | vlan } |
[ tunnel-policy
tunnel-policy-name ]
[ backup-peer ip-address vcid
[ backup-tunnel-policy
tunnel-policy-name | revertive
[ wtr-time wtr-time ] ] * ] ] *
mpls l2vc switchover
162
Remarks
N/A
N/A
To implement VC redundancy,
specify the backup-peer keyword
to create a backup VC.
Optional.