HP HSR6800 Configuration Manual page 429

[PE1-bgp] peer 3.3.3.9 as-number 100
[PE1-bgp] peer 3.3.3.9 connect-interface loopback 0
[PE1-bgp] peer 3.3.3.9 label-route-capability
# Configure the maximum hop count from PE 1 to EBGP peer 5.5.5.9 as 10.
[PE1-bgp] peer 5.5.5.9 as-number 600
[PE1-bgp] peer 5.5.5.9 connect-interface loopback 0
[PE1-bgp] peer 5.5.5.9 ebgp-max-hop 10
# Configure peer 5.5.5.9 as a VPNv6 peer.
[PE1-bgp] ipv6-family vpnv6
[PE1-bgp-af-vpnv6] peer 5.5.5.9 enable
[PE1-bgp-af-vpnv6] quit
# Redistribute direct routes to the routing table of vpn1.
[PE1-bgp] ipv6-family vpn-instance vpn1
[PE1-bgp-ipv6-vpn1] import-route direct
[PE1-bgp-ipv6-vpn1] quit
[PE1-bgp] quit
2. Configure ASBR-PE 1:
# Start IS-IS on ASBR-PE 1.
<ASBR-PE1> system-view
[ASBR-PE1] isis 1
[ASBR-PE1-isis-1] network-entity 10.2222.2222.2222.00
[ASBR-PE1-isis-1] quit
# Configure an LSR ID, and enable MPLS and LDP.
[ASBR-PE1] mpls lsr-id 3.3.3.9
[ASBR-PE1] mpls
[ASBR-PE1-mpls] label advertise non-null
[ASBR-PE1-mpls] quit
[ASBR-PE1] mpls ldp
[ASBR-PE1-mpls-ldp] quit
# Configure interface Serial 2/1/1, and start IS-IS and enable MPLS and LDP on the interface.
[ASBR-PE1] interface serial 2/1/1
[ASBR-PE1-Serial2/1/1] ip address 1.1.1.1 255.0.0.0
[ASBR-PE1-Serial2/1/1] isis enable 1
[ASBR-PE1-Serial2/1/1] mpls
[ASBR-PE1-Serial2/1/1] mpls ldp
[ASBR-PE1-Serial2/1/1] quit
# Configure interface Serial 2/1/2 and enable MPLS on it.
[ASBR-PE1] interface serial 2/1/2
[ASBR-PE1-Serial2/1/2] ip address 11.0.0.2 255.0.0.0
[ASBR-PE1-Serial2/1/2] mpls
[ASBR-PE1-Serial2/1/2] quit
# Configure interface Loopback 0 and start IS-IS on it.
[ASBR-PE1] interface loopback 0
[ASBR-PE1-LoopBack0] ip address 3.3.3.9 32
[ASBR-PE1-LoopBack0] isis enable 1
[ASBR-PE1-LoopBack0] quit
# Create routing policies.
421