HP HSR6800 Configuration Manual page 116

-----------------------------------------------------------------
2.2.2.9:0
-----------------------------------------------------------------
LAM : Label Advertisement Mode
7. Create an MPLS TE tunnel:
# Create an MPLS TE tunnel on Router A.
[RouterA] interface tunnel 2
[RouterA-Tunnel2] ip address 8.1.1.1 255.255.255.0
[RouterA-Tunnel2] tunnel-protocol mpls te
[RouterA-Tunnel2] destination 4.4.4.9
[RouterA-Tunnel2] mpls te tunnel-id 10
[RouterA-Tunnel2] mpls te signal-protocol crldp
[RouterA-Tunnel2] mpls te commit
[RouterA-Tunnel2] quit
Execute the display interface tunnel command on Router A. You can see that the tunnel
interface is up.
[RouterA] display interface tunnel
Tunnel2 current state: UP
Line protocol current state: UP
Description: Tunnel2 Interface
The Maximum Transmit Unit is 64000
Internet Address is 8.1.1.1/24 Primary
Encapsulation is TUNNEL, service-loopback-group ID not set
Tunnel source unknown, destination 4.4.4.9
Tunnel protocol/transport CR_LSP
Output queue : (Urgent queuing : Size/Length/Discards)
Output queue : (Protocol queuing : Size/Length/Discards)
Output queue : (FIFO queuing : Size/Length/Discards)
Last 300 seconds input:
Last 300 seconds output:
0 packets input,
0 input error
0 packets output,
0 output error
Execute the display mpls te tunnel-interface command on Router A to view information about
the tunnel.
[RouterA] display mpls te tunnel-interface
Tunnel Name
Tunnel Desc
Tunnel State Desc :
Tunnel Attributes :
LSP ID
Session ID
Admin State
Ingress LSR ID
Signaling Prot
Class Type
Reserved BW
Operational DU
0 bytes/sec, 0 packets/sec
0 bytes/sec, 0 packets/sec
0 bytes
0 bytes
: Tunnel2
: Tunnel2 Interface
CR-LSP is Up
: 1.1.1.9:2
: 10
: UP
: 1.1.1.9
: CR LDP
: CT0
: 2000 kbps
108
Passive Off Off
FT : Fault Tolerance
0/75/0
Oper State
Egress LSR ID:
Resv Style
Tunnel BW
11/11
0/100/0
0/500/0
: UP
4.4.4.9
: -
: 2000 kbps