Mpls L2Vpn Configuration Examples; Example For Configuring A Local Ccc Connection - HP HSR6800 Configuration Manual

Task
Display MPLS L2VPN PW
information. (In standalone
mode.)
Display MPLS L2VPN PW
information. (In IRF mode.)
Display information about one or
all PW classes.

MPLS L2VPN configuration examples

Example for configuring a local CCC connection

Network requirements
The CEs are connected to the PE through Serial interfaces. The link layer encapsulation protocol is
PPP.
Create a local CCC connection on the PE, so the PE can directly forward packets between CE 1 and
CE 2 without looking up the forwarding table, improving the forwarding speed.
Figure 45 Network diagram
S2/1/0
100.1.1.1/24
CE 1
Configuration considerations
Because a local CCC connection is bidirectional, one local CCC connection is enough for CE 1 and
CE 2 to communicate with each other.
Configuration procedure
1. Configure CE 1:
# Configure the link protocol type as PPP on interface Serial 2/1/0 (the interface connected to
the PE), and configure an IP address for the interface.
Command
display mpls l2vpn fib pw vpws
[ interface interface-type
interface-number [ service-instance
service-instanceid ] ] [ slot slot-number ]
[ verbose ] [ | { begin | exclude | include }
regular-expression ]
display mpls l2vpn fib pw vpws
[ interface interface-type
interface-number [ service-instance
service-instanceid ] ] [ chassis
chassis-number slot slot-number ]
[ verbose ] [ | { begin | exclude | include }
regular-expression ]
display pw-class [ pw-class-name ] [ |
{ begin | exclude | include }
regular-expression ]
Local CCC connection
S2/1/0
CE 2
S2/1/0
100.1.1.2/24
S2/1/1
PE
Loop0
172.1.1.1/32
168
Remarks
Available in any view.
Available in any view.
Available in any view.