HP HSR6800 Configuration Manual page 201

Configuration procedure
1. Configure CE 1:
# Configure an IP address for interface Ten-GigabitEthernet1/0/1, the interface connected to
PE 1.
<Sysname> system-view
[Sysname] sysname CE1
[CE1] interface ten-GigabitEthernet 1/0/1
[CE1-Ten-GigabitEthernet1/0/1] ip address 100.1.1.1 24
2. Configure PE 1:
<Sysname> system-view
[Sysname] sysname PE1
[PE1] interface loopback 0
[PE1-LoopBack0] ip address 192.2.2.2 32
[PE1-LoopBack0] quit
# Configure the LSR ID and enable MPLS globally.
[PE1] mpls lsr-id 192.2.2.2
[PE1] mpls
[PE1-mpls] quit
# Enable L2VPN and MPLS L2VPN.
[PE1] l2vpn
[PE1-l2vpn] mpls l2vpn
[PE1-l2vpn] quit
# Enable LDP globally.
[PE1] mpls ldp
[PE1-mpls-ldp] quit
# Configure PE 1 to establish an LDP remote session with PE 2.
[PE1] mpls ldp remote-peer 1
[PE1-mpls-ldp-remote-1] remote-ip 192.3.3.3
[PE1-mpls-ldp-remote-1] quit
# Configure the interface connected with the P device and enable LDP on the interface.
[PE1] interface ten-GigabitEthernet 1/0/2
[PE1-Ten-GigabitEthernet1/0/2] ip address 23.1.1.1 24
[PE1-Ten-GigabitEthernet1/0/2] mpls
[PE1-Ten-GigabitEthernet1/0/2] mpls ldp
[PE1-Ten-GigabitEthernet1/0/2] quit
# Configure OSPF.
[PE1] ospf
[PE1-ospf-1] area 0
[PE1-ospf-1-area-0.0.0.0] network 23.1.1.1 0.0.0.255
[PE1-ospf-1-area-0.0.0.0] network 192.2.2.2 0.0.0.0
[PE1-ospf-1-area-0.0.0.0] quit
[PE1-ospf-1] quit
# On the interface connected to CE 1, create a service instance and then create a VC.
[PE1] interface ten-gigabitethernet1/0/1
[PE1-Ten-GigabitEthernet1/0/1] port link-mode bridge
[PE1-Ten-GigabitEthernet1/0/1] service-instance 1
[PE1-Ten-GigabitEthernet1/0/1-srv1] encapsulation untagged
193